User`s manual

Installing the device drivers Quatech SDS User’s Manual
Page 34 940-0183-155 April 2008
Figure 29 - TCP/IP Network Configuration Parameters screen
Step Procedure Description
 Step 38 If you are satisfied with the parameters,
press Next to continue.
If you are not satisfied, press Change
Properties to change the TCP/IP
properties.
The Rerun network connectivity test pop-
up box displays.
Continue with □ Step 39.
The Internet Protocol (TCP/IP)
Properties dialog box displays.
Go to □ Step 32.
Figure 30 - Rerun network connectivity test pop-up box
Step Procedure Description
 Step 39 Press OK. The Network Connectivity Test screen
displays. Go to □ Step 14.
Figure 30 shows the TCP/IP
network configuration parameters
including the following:
¾ Address type
¾ IP Address
¾ Subnet mask
¾ Default gateway
Figure 31 shows the Rerun
network connectivity test pop-
up box.