User`s manual

Furthermore, some systems use the high memory area for BIOS shadowing to improve
overall system performance. In order for the Enabler to operate, any BIOS shadowing
must be disabled in the address range specified for the configuration window. BIOS
shadowing can usually be disabled through the system's CMOS setup utility.
Socket Numbers:
The Enabler requires the DSP-200/300's socket number to be specified on the command
line and the DSP-200/300 must be inserted into the socket before the Enabler is
invoked. Some vendors number their sockets from 1 to N while other vendors number
their sockets from 0 to N-1. For theDSP-200/300 Enabler, the lowest socket number in
the system is designated socket 0.
Card and Socket Services Software:
In order to use the DSP-200/300 Enabler for DOS, the system MUST NOT be
configured with Card and Socket Services software. If a Card and Socket Services
software is installed, the Enabler may interfere with its operation and with the device(s)
it controls. For systems configured with Card and Socket Services, the DSP-200/300
Client Driver is the recommended method of configuration.
2-17 DSP-200/300 (Rev. I and later) User's Manual
www.bb-elec.com [e-mail] [e-mail]
International Office: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA 815-433-5100 Fax [phone]
European Office: Westlink Commercial Park Oranmore Co. Galway Ireland [phone] Fax [phone]