User`s manual

Older Versions of Card and Socket Services:
Some versions of Card and Socket Services dated before 1993 do not support general
purpose I/O cards. If after careful installation of the Client Driver the DSP-200/300
does not configure or operate properly, an updated version of Card and Socket Services
may be required. Card and Socket Services software is available from Quatech.
2.2 DSP-200/300 Enabler for DOS
For systems that are not operating PCMCIA Card and Socket Services software, the
DSP-200/300 DOS Enabler may be used to enable and configure the adapter. This
Enabler, DSP230EN.EXE, will operate on any DOS system using an Intel 82365SL or
PCIC compatible PCMCIA host adapter including the Cirrus Logic CL-PD6710 /6720,
the VLSI VL82C146, and the Vadem VG-365 among others.
IMPORTANT:
In order to use the DSP-200/300 Enabler for DOS, the
system MUST NOT be configured with Card and Socket
Services software. If a Card and Socket Services software is
installed, the DSP-200/300 Enabler may interfere with its
operation and with the device(s) it controls.
The DSP-200/300 Enabler does not support automatic configuration of adapters upon
insertion, more commonly referred to as "Hot Swapping". This means the adapter must
be installed in one of the system's PCMCIA sockets before executing DSP230EN.EXE. If
more than one adapter is installed in a system, the Enabler must be executed separately
for each adapter. Furthermore, DSP230EN.EXE should be executed to release the
resources used by the adapter before it is removed from the PCMCIA socket. Since
PCMCIA adapters do not retain their configuration after removal, any adapter that is
removed from the system must be reconfigured with the Enabler after re-inserting it
into a PCMCIA socket.
2-11 DSP-200/300 (Rev. I and later) User's Manual
www.bb-elec.com [e-mail] [e-mail]
International Office: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA 815-433-5100 Fax [phone]
European Office: Westlink Commercial Park Oranmore Co. Galway Ireland [phone] Fax [phone]