Specifications

Tritech International Ltd SeaKing System Options OM
Issue 3 TIL – Eng – Spec – 040 Page 10 of 44
Part 2: Changing Resources using Device Manager
1. Start => Settings => Control Panel.
2. Double click on System.
3. Select the Device Manager tab.
4. Double click on Multi-function adapters.
5. Highlight Quatech DS-100: 2 RS-232 Ports and click on Properties.
6. Select the Resources tab.
7. Ensure that there are two input/output ranges set at ‘03E8 – 03EF’ and ‘02E8 – 02EF’
respectively.
8. If the first Interrupt Request in the list is not 05, then:
• Highlight the first Interrupt Request => Click on Change Setting.
• Change the Interrupt value from XX to 5 (where XX is the default IRQ number)
=> Click on OK.
9. If the second Interrupt Request in the list is not 11, then:
• Highlight the second Interrupt Request => Click on Change Setting.
• Change the Interrupt value from XX to 11 (where XX is the default IRQ number)
=> Click on OK.
10. Click on OK.
11. When prompted, remove any disks from drives and restart the SCU.
Part 3: Check Quatech Serial Ports COM3 & COM4 are available
1. Start => Settings => Control Panel.
2.
Double click on System.
3. Select the Device Manager tab.
4. Double click on Ports (COM & LPT).
NB: Quatech serial port (COM 3) & Quatech serial port (COM 4) should be displayed in the list.
5. Highlight Quatech Serial Port (COM 3) => Click on Properties.
6. Select the Resources tab.
• Interrupt Request should be set at 05.
• Input/Output range should be set at 03E8 – 03EF.
=> Click on OK.
7. Highlight Quatech Serial Port (COM 4) => Click on Properties.
8. Select the Resources tab.
• Interrupt Request should be set at 11.
• Input/Output range should be set at 02E8 – 02EF.
=> Click on OK.
9. Click on OK.
NB: If any of the Quatech Serial Port COM3 or COM4 settings are not correct, repeat Part 2:
Changing Resources using Device Manager.