Specifications

Tritech International Ltd SeaKing System Options OM
Issue 3 TIL – Eng – Spec – 040 Page 43 of 44
Click on the 'Remote Comms Setup' button and configure the allocated channel…
…In this example Channel 1 has been assigned and this is allocated with the COM1 port as
default. Ensure this COM port is Enabled
(=True) and configured to match the Terminal that is
sending the annotate messages.
Sidescan Plotter Menu controls
When the Alden Plotter control has been enabled in the "SONV3SO.INI" file (see earlier), the
Plotter Control Panel will appear minimised in the bottom left corner of the Sidescan display…
…Double-click on this panel to maximise to the following…
The Plotter Control is where a number of settings are configured. These are now described;
Plotter Status - This text
appears on the Top Left of Panel and indicates the following statuses;
▪ Plotter Off (or Disconnected)
▪ Plotter Offline
▪ Plotter Online
Plotter Output - This check-box
is used to toggle On ('x') and Off (' ') the data output to the plotter
when the Sidescan is active.
Neg. - This check-box
toggles between a Negative Output (black -> white and vice-versa) when
switched On ('x').
Brightness - Use the slider bar
to increase/decrease the value of the brightness intensity for the
Plotter output.
Contrast - Use the slider bar
to increase/decrease the contrast setting of the Plotter output.
Line Repeat - Same Control as on plotter. Use slider bar
to vary number.
Gridlines - Use the slider bar
to vary the number of Gridlines on the Plotter Output.
Annotation on Left:
drop-down list and display box
Annotation on Right:
drop-down list and display box