User`s guide

Using VCOM
Page 70 AirborneDirect™ Serial Bridge User’s Guide 100-8006-152G
Quatech, Inc. Confidential
MODIFYING VIRTUAL COM PORT PARAMETERS
To select virtual COM port parameters, use the following procedure:
• In the VCOM List pane, click the virtual COM port whose parameters you want to
change. The right side of the window displays the current parameters for the virtual COM
Port you selected.
Using the parameter controls on the right side of the window, select the desired settings for the
selected virtual COM port (see Table 11 on page 69).
Note:
When modifying virtual COM port parameters, the parameters VCOM Port
and Port Type become read-only fields and cannot be changed.
• Click the Save button. If you changed the VCOM Settings, the message in Figure 41
appears.
Figure 41. Reboot Message
• Click the OK button.
• Reboot your computer to have your VCOM settings take effect.
DELETING VIRTUAL COM PORTS
If you no longer need a virtual COM port, use the following procedure to delete it:
Note:
A precautionary message does not appear before you delete a virtual COM
port. Therefore, be sure you no longer need a virtual COM port before you
delete it. If you delete a virtual COM port that you need, use the procedure
on page 68 to add it again.
• In the VCOM List pane, click the virtual COM port you want to delete.
• Under the VCOM List pane, click the Delete button. The selected virtual COM port is
deleted from the pane.
• To delete additional virtual COM ports, repeat steps 1 and 2.