User`s guide

Using VCOM
Page 68 AirborneDirect™ Serial Bridge User’s Guide 100-8006-152G
Quatech, Inc. Confidential
LISTING VIRTUAL COM PORTS
To view the available virtual COM ports, click the List button below the VCOM List pane.
Clicking this button refreshes the virtual COM ports shown in the pane.
ADDING VIRTUAL COM PORTS
To add virtual COM ports, use the following procedure:
• Under the VCOM List pane, click the Add button. The VCOM Configuration Utility
window appears as in Figure 39.
Figure 39. Adding a Virtual COM Port
• Using the parameter controls on the right side of the window, select the desired settings
for the virtual COM port you are adding (see Table 11).
Note:
The virtual COM port parameters are organized into two sections, VCOM
Settings and NMS Settings. If you change the VCOM Settings, you must
reboot your computer for your selections to take effect. If you change the
NMS Settings, you do not need to reboot.
• Click the Save button. If you changed VCOM settings, the message in Figure 40
appears.