User`s guide

Airborne Control Center
Page 38 AirborneDirect™ Serial Bridge User’s Guide 100-8006-152G
Quatech, Inc. Confidential
UDP Connection Settings
UDP Target IP
Address
Configures the IP address to use when the Serial Host wishes to send UDP data
packets to a remote UDP listener/server.
Default is: 0.0.0.0.
UDP Target Port
Configures the UDP port number to use when the Serial Host wishes to send UDP
unicast data packets to a remote listener/server.
Default is: 8023 (decimal).
UDP Listen Port
Configures the UDP port the Tunnel server will listen on for inbound UDP data.
Unicast and broadcast packets will be received and transferred to the serial
interface.
Only when the Module is in pass mode will UDP payload be conveyed to the serial
interface.
Default is 8023 (decimal).
UDP Transmit Mode
Configures the outbound UDP transmission mode.
disable – disables outbound UDP packet transmission.
ucast – enables UDP unicast only.
bcast – enables UDP broadcast only.
both – enables UDP broadcast and unicast – a broadcast and a unicast
packet is transmitted. If wl-xmit-type is set to both, three packets
will be transmitted: TCP, UDP unicast, and a UDP broadcast.
Default is disable.