User`s guide

Hardware Installation
100-8006-152G AirborneDirect™ Serial Bridge User’s Guide Page 19
Quatech, Inc. Confidential
Indicator LEDs
The Heavy-Duty Bridge has four indicator LEDs for viewing its current status and connections
(see Figure 8). These indicators allow for monitoring and troubleshooting of the Bridge. They
also indicate the Bridge’s power-up status, link, connection, and data-activity status. Table 3
describes the status of the indicator LEDs.
Table 3. AirborneDirect™ Heavy-Duty Serial Bridge Indicator LEDs
Name Description
POST Power on self test completed
CFG Device has a valid IP address
LINK Device has successfully
associated/authenticated with an AP.
CONN TCP/IP connection established with
device.
End Cap Layout
The connectors required to attach to the device are:
Interface and Power: Deutsch DTM-06-12SSA
RF: RP-SMA (Male)
Note: FACTORY RESET hole is optional, if a sealed enclosure is required.
Figure 10. End Cap Pin-out and Connector Location
CONN
LINK
CFG
POST