User`s guide

Hardware Installation
100-8006-152G AirborneDirect™ Serial Bridge User’s Guide Page 11
Quatech, Inc. Confidential
STANDARD PACKAGE HARDWARE DESCRIPTION
Figure 3 identifies the components on the Bridge in its standard packaging. These components
include:
 An external antenna.
 A DB9 male DTE connector and cable attached to the Bridge.
 A Reset switch and interface selector shunts on the bottom of the Bridge.
 Three indicator Light Emitting Diodes (LEDs) on the top of the Bridge.
 A mounting cradle.
Figure 3. AirborneDirect™ Serial Bridge Hardware (standard package)
Reset Switch
The bottom of the AirborneDirect™ Bridge provides access to a Reset Switch. The Reset switch
returns all Bridge parameters to their factory default firmware settings. To reset Bridge
parameters, press (and hold) this switch for at least 5 seconds after power is applied to the
Bridge. To protect against accidental resets, the Reset switch is recessed.