User`s guide

Introduction
100-8006-152G AirborneDirect™ Serial Bridge User’s Guide Page 5
Quatech, Inc. Confidential
USING THIS DOCUMENT
In addition to this chapter, this guide contains the following chapters and appendixes:
 Chapter 2, Hardware Installation ⎯ describes the AirborneDirect™ Serial Bridge
hardware and how to install it.
 Chapter 3, Initial Configuration ⎯ describes how to configure the AirborneDirect™
Serial Bridge on your network.
 Chapter 4, Using the Airborne Control Center (ACC) ⎯ describes how to use the
Windows-based application to configure, manage and view the status of
AirborneDirect™ Serial Bridges.
 Chapter 5, Using VCOM ⎯ describes how to use VCOM to provide a LAN-based
serial connection to the AirborneDirect™ Serial Bridge.
 Chapter 6, Troubleshooting ⎯ provides troubleshooting suggestions in the unlikely
event you encounter a problem using the AirborneDirect™ Serial Bridge.
 Appendix A, UDP and Power Management ⎯ lists the AirborneDirect™ Serial
Bridge specifications.
 Appendix B, Cable Replacement ⎯ contains information for replacing the cable.
 Appendix C, Specifications ⎯ lists the AirborneDirect™ Serial Bridge
specifications.
 Appendix D, FCC Compliance ⎯ contains FCC compliance information.
 Appendix E, ASLIP Protocol ⎯.provides information on the transmission of IP
Datagrams over Serial using Airborne WLN.
 Glossary ⎯ defines the terms associated with the AirborneDirect™ Serial Bridge
and wireless networks in general.
For convenience, an Index appears at the end of this guide.