Operating instructions

Check the following points once a(
No power..
No picture or sound,..
Poor picture with normal sound..
Poor sound with normal picture,..
Poor TV reception...
No color or poor color..
Ghost (multiple) images...
TV programs cannot be watched...
Channel cannot be selected...
TV program cannot be recorded...
Timer recording cannot be
_erformed...
No playback picture, or the playback
)icture is noisy or contains streaks...
VCR cannot be controlled,..
Unit cannot be control;ed .
Video cassette cannot be inserted..
Video cassette cannot be removed
Tape cannot be ejected or inserted,
Video cassette ejects when a
recording is started, or the power is
turned off for timer recording...
In Stop mode, the VCR motor
(CYLINDER) continues to rotate.
VCR cannot be controlled..
am if you are having trouble with your unit.
• Completely insert Power Plug into an AC ouPet
• Set POWER button to ON
Make sure your antenna system (TV or CABLE), is correclly set (P 7)
Completely insert Power Plug into an AC outlet
Set POWER button to ON.
Adjust BRIGHTNESS, SHARPNESS, and PICTURE conlrols in the SET UP
TV menu. (P 11)
• Adjust VOLUME control, (P. 10)
• Adjust SHARPNESS and PICTURE controls in the SET UP TV menu. (P. 11)
Adjust TINT and COLOR controls in the SET UP TV menu. (P. 11)
Install a directional antenna.
• Make sure the selected channel is in unit's memory. (P 34)
• Only the channel begin recorded can be viewed on this und.
• Make sure your antenna system (TV or CABLE), is correctly set. (P. 7)
• Make sure cassette record tab is intact. (P 6)
• Check that clock is set to current time and date
• Make sure DSS/CABLE box (if used) is left on and tuned to channel to be
recorded.
• Set recording Start/Stop time correctly. (P. 14, 15)
• Timer recording may not be performed or continued if a power interruption of
more than 1 minute occurs before or during a Timer recording even after
power is restored.
• Adjust TRACKING control in either direction, (P 12)
• Try Head Cleaning (P. 35)
• Make sure VCR LOCK is set to off. (P. 28)
• Make sure unit is not in s Timer Record operation.
• Aim remote at remote sensor on unit (P. 43) so that signal is unobstructed.
• Inspect the remote batteries. (P. 6)
• Make sure VCR LOCK is set Looff. (P. 28)
• Exposing unit remote sensor to direct fluorescent or outdoor light may cause
signal interference
• Insert the cassette window side up; record tab facing you
• Completely insert Power Plug into an AC outlet.
• Try ejecting or inserting the tape again after turning POWER off, then back
on.
Make sure cassette record tab is intact. (P 6)
To enable Quick Play mechanism, the VCR cylinder will rotale for about 5
minutes. This reduces response time from Stop to Play mode and from Play
to Rewind Search mode
Make sure VCR LOCK is set to off (P 28)
Thank you for your purchase.
For service of this Quasar product, please contact your local Sears Service Center.
To locate the closest Sears Service Center call toll free 1-800-488-1222.
4O