Panasonic ° Palnlcor, dcP DisplayMatc LCD Monitor Operating Instructions PV-LCD35 Before attempting to connect, operate or adjust this product, please read these instructions thoroughly. Specifications Power Source: Power Consumption: LCD Monitor: Audio/Video Input: Ear Phone Jack: Operating Temperature: Operating Humidity: Weight: Dimensions: DC 6V 4.6W 3.2 inch (81.2mm) Liquid Crystal Display M3 Connector M3 Type 32°F~104°F (0°0~40°C) 10%~75% 0.72 Ibs. 0.
7['hulzh you lbr choo._ing l'alt_sol_ic/ You have purchased one of the most sophisticated and reliable products on the market today. Used properly, we're sure it will bring you and your family years of enjoyment. Please take time to fill in the information at right. The serial number of this product may be found on the surface of the unit. Be sure to retain this manual as your convenient LCD monitor information source. ('Date of Purchase Dealer Purchased From Dealer Address Dealer Phone No. Model No.
SLIDE RELEASE Switch Earphone Jack (Monaural) Connect the earphone (M3 type, not supplied) to the earphone jack for monitoring the sound during playback or recording. Power Indicator Power Swit Audio/Video Input PI Jg LCD (Liquid Crystal Display) Monitor Battery Release DO Input Connector Built-In Speaker and Volume Control For monitoring the sound during playback or recording. You can adjust the sound by rotating the volume control down for maximum or up for minimum.
® Attach the LCD monitor Align the LCD monitor with the top of the mounting surface. Press it into place until it locks with a click. (_ Connect the Audio/Video Input Plug to the Audio/Video Output Connector. Remove the LCD monitor Disconnect the Audio/Video Input Plug from the Audio/video Output Connector. While sliding the BATTERY RELEASE button on the Palmcorder, remove the LCD monitor.
To supply power to the Palmcorder and LCD monitor: Attach the Battery Pack or connect the DC Power Cable to the LCD monitor. oLJ" Note: Using the LGD rrJ_nitor _uduce5 battery operating time. It is recommended to use 1.8Ah Battery Pack (PV-BP18) or 2.4Ah Battery Pack (PV-BP17) when using the LCD monitor. Set the POWER switch to AUTO ON. The LCD monitor will then turn on/off according to the Palmcorder's POWER switch setting. Set the POWER switch to OFF to turn off the LCD monitor only.
Matsushita Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way Secaucus, New Jersey 07094 Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. ("PSC") Ave. 65 de Infanteria. Km. 9.5 San Gabriel Industrial Park, Carolina, Puerto Rico 00985 Tel. (809)750-4300 Fax.
1. Read Irlstfuuhons All tl_c bdluty died u#uldUng instructions should be read before the unit is operated. 2. Retain Instructions -- The safety and operating instructions should be retained for future reference. 3. Heed Warnings -- All warnings on the unit and in the operating instructions should be adhered to. 4. Fo'L}ow 'instructions -- All operating and maintenance instructions should be followed. 5. 6. 7. 8. Cleaning -- Unplug this video unit from the wall outlet before cleaning.
15. I'OVvul Lirlus -- An outside antelllla, systelli should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. b. If any liquid has been _pitled unto, ur objects have fallen into the video unit. c. If the video unit has been exposed water. d.
