Installation guide

Document Information

vii

1 Document Information

Document Scope and Purpose

The purpose of this document is to provide instructions and installation procedures for physically

connecting the Quasar camera. After completing the physical installation, additional setup and

configurations may be required before video analysis and detection can commence.

Note:

This document is intended for use by technical users who have a basic

understanding of CCTV camera/video equipment and LAN/WAN network

connections.

Warning:

Installation must follow safety, standards, and electrical codes as well as the laws

that apply where the units are being installed.

Proprietary Rights and Non-Disclosure

This manual is delivered subject to the following restrictions and conditions:

 This document contains proprietary information belonging to DVTEL, Inc. This information

is supplied solely for the purpose of assisting explicitly the licensee of the DVTEL units.

 No part of this document contents may be used for any other purpose, disclosed to any

third party or reproduced by any means, electronic or mechanical, without the express

prior written permission of DVTEL, Inc.

Trademarks and Copyrights

DVTEL, the DVTEL logo, Quasar CM-4251 are trademarks of DVTEL, Inc.

Products and trademarks mentioned herein are for identification purposes only and may be

registered trademarks of their respective companies.

DVTEL, Inc. makes no representations whatsoever about any other products or trademarks

mentioned in the manual.