Quick Start Guide

Lead/Follow Mode
15
•Lead/Follow mode allows one lamp to control many lamps at once. The Lead transmits DMX data wired or wirelessly to the Follows.
When the Lead changes levels, the Follows will change as well. This applies to on board FX as well.
•To use Lead/Follow mode, go to Config -> Lead/Follow. Set the leader to Lead and set all of the followers to Follow 1 to match the leader.
Follow 2-8 are used with effects to do the same effect with different timings. This will run the same effects, intensities and levels but not in sync.
•To use Lead/Follow wired, plug a Cat5 cable into the DMX OUT port of the leader into the In of the followers. Repeat out of the followers
and into the next. The Data light should be illuminated on all the followers.
•To use Lead/Follow wirelessly, on the followers, press and hold to unpair the lamp. Next tap on the leader. On all of the followers,
the Wireless signal light should begin flashing and then remain solid.
MODE
Lead
MODE
Follow 1
=
MODE
Follow 1
MODE
Follow 1
MODE
Lead
MODE
Follow 2
=
MODE
Follow 4
MODE
Follow 3
+ x sec. + y sec. + z sec.