Quick Start Guide

Config Menu

> DMX Channel

> Number of Pixels

> Profile

> Wired Settings

> Wireless Settings

> Lead / Follow

> Output Mode

> Rig Mode

> Status Lights

> Languages

> Lamp Hours

> Update Firmware

> Firmware

> Reset to Default

Set the DMX Channel.

Control the light as groups. (See Page 12)

Set the DMX profile for the light. (See Page 18-23)

Select the Wired data options to control the light. (DMX, Art-Net, sACN) (See Page 13)

Select the Wireless data options. (CRMX, Bluetooth, Wifi) (See Page 14)

Set Lead/Follow mode for the light. (See Page 15)

Set the lamp to Normal Output, High Output, or Low Output Mode.(See Page 16)

When Enabled, turns on when it is powered. When disabled, requires power button pressed. (See Page 16)

Turns the status lights on/off for use on camera.

English (Check the website for additional languages.)

Displays the total hours the lamp has been powered on. Press Enter to See LED Hours.

Set the lamp into Update mode.

Displays the firmware version on the lamp.

Sets the lamp back to all its default values.