Installation Guide

3
Linear drainage options
Installation against the wall Walk-through: installation against the wall Walk-in: installation against the wall
Simplest slope solution in one direction – slope
away from the bathroom – no risk of bypass –
use of CPE flexible membrane is recommended.
Slope in one direction – just shower area or
whole bathroom floor can be sloped towards
channel – use of CPE flexible membrane is
recommended.
Simplest slope solution in one direction –
slope away from the bathroom – no risk of
overshooting water – use of CPE exible
membrane is recommended.
Installation at shower entrance Walk-through: installation with two channels Walk-in: installation at the entrance
Slope in one direction, towards the bathroom –
possible risk of bypass – slope of bathroom
floor towards shower area is recommended to
prevent bypass. Channel length should exactly
fit the shower opening.
Two directional slope towards the bathroom.
Channel length should exactly fit the shower
opening.
Two directional slope towards the channel.
Channel length should exactly t the shower
opening.
Point installation at shower center Installation with multiple point drains
Use single ShowerPoint drain within shower
area. Floors must be graded up to 2% or
other barriers must be used to prevent flow of
water into bathroom area.
With multiple ShowerPoint drains positioned
within both shower and bathroom areas, level
threshold oors can be used as bathroom
ShowerPoint will also drain any liquid from
cleaning or other bathroom xtures.
Drainage planning information