Installation Instructions

3. Pipe Boot Placement
Apply a bead of a polyurethane sealant on the rim of the plumbing pipe.
Place the Pipe Boot over the plumbing pipe seating the TightLOCK Top
on to the pipe. Turn the top clockwise 1/8” so that the TightLOCK Top is
secured. Nail the base to the roof using the embossed guides. Install two
nails into flange on the back of the base.
4. Finishing
Continue installing shingles, lap the shingles over the side and back
flanges (notch as required). Apply a bead of sealant to the exposed nail
heads on the base.
PiPe Boot eXteNder
The Extender is designed to adapt the Pipe Boot for pipes that are 15”
to 24” tall.
Simply slide the expanded end of the Extender on to the Pipe Boot inner
sleeve. The plumbing pipe should extend enough (2” to 3”) above the
extender to allow for roof expansion and contraction. The Extender may
be cut to size. Apply a bead of a polyurethane sealant on the rim of the
plumbing pipe. Place the Pipe Boot over the plumbing pipe seating the
TightLOCK Top on to the pipe. Turn the top clockwise 1/8” so that the
TightLOCK Top is secured.
Quarrix Building Products | 705 Pennsylvania Ave. | Minneapolis, MN 55426 USA | www.quarrix.com | 800.438.2920
QuArriX PiPe Boot
INSTALLATION INSTRUCTIONS
QUARRIX BUILDING PRODUCTS