9.3

Table Of Contents
In this tab, you can separately configure each corner of the box by unchecking Same for
all, or check Same for all and configure all four corners with a single set of controls.
Whichever way you do it, you can use the drop-down menu to specify a corner type
(Normal, Rounded, Beveled, Concave, Pointed, or Inset) and a diameter (for options
that involve a diameter).
Curvature: Controls how curved the corners are if you select an option that includes
curvature.
Balance: For some options, lets you control whether the corners lean toward the sides of
the box or toward the top.
Radial: For some options, lets you control whether the corners of the box are aligned with
the center of the box or not.
ShapeMaker Presets tab
The Presets tab of the ShapeMaker dialog box (Utilities > ShapeMaker) lets you store
settings that you like so that you can reuse them later.
Presets tab of ShapeMaker dialog box
To store all of the settings in all tabs of the ShapeMaker dialog box, enter a name in the
Name field and click Save. An entry is added to the list on the left, with an image of the
shape from the last tab you were looking at.
To load a set of saved settings, select it in the list on the left, click Use Settings, then go
to the desired tab and create the shape you want.
To replace the settings stored with an entry, select the entry and click Replace.
To delete an entry, select it and click Delete.
To rename an entry, select it and click Rename.
To restore all tabs of the ShapeMaker dialog box to the settings they had when you opened
the dialog box, click Revert All.
476 | A GUIDE TO QUARKXPRESS 9.3
XTENSIONS SOFTWARE