2018

OUTPUT
364 | A Guide to QuarkXPress 2018
F
onts pane
U
se the Fonts pane to specify which fonts are included in output. Note that many
of the options in this pane are available only when printing to a PostScript output
device.
To read the list of downloaded fonts from the printer’s PPD file, check Use PPD•
Font Settings. Fonts listed in the PPD file are not downloaded. Checking this
b
ox disables many of the other controls in this tab.
I
f you are printing to a PostScript level 3 or later output device, or to a device•
that uses PostScript level 2 version 2015 or later, check Optimize Font Formats.
To download all fonts used in the layout , check Download Layout Fonts. To•
control which fonts are downloaded, uncheck Download Layout Fonts and
then check Download for each font you want to download. You can control
which fonts are listed by choosing an option from the Show drop-down menu.
To download all fonts that are required by imported PDF and EPS files, check•
Download Imported PDF/EPS Fonts.
To retrieve a list of the fonts included on the active printer, click Scan Printer.•
Note that this process can take a long time; you may want to check Use PPD
Font Settings, and use your printer manufacturer’s PPD file. (Windows only)
Color pane
Use the Color pane to control color output.
To print all colors on one page, choose Composite from the Mode drop-down•
menu. To print to a device that handles in-RIP separations, choose Separations
from the Mode drop-down menu. For more information about composite
output, see “
Printing color composites.”
To specify an output setup for the output device, choose an option from the•
Setup drop-down menu. For more information about color management, see
“
Source setups and output setups.”
To specify default halftone shape and frequency, use the Halftones and•
Frequency drop-down menus. The Printer option on the Halftones drop-down
menu lets the output device determine all halftone settings.
Registration Marks pane
Use the Registration Marks pane to include crop marks, registration marks, and
bleed marks in the output. Crop marks are short vertical and horizontal lines printed
outside the page’s final trim size, indicating where to cut the page. Registration marks
are symbols that are used to align overlaying plates. Bleed marks indicate where page
bleeds end.
To include crop marks and registration marks on every page, choose Centered or•
Off Center from the Mode drop-down menu.
When you choose Centered or Off Center, the Width, Length, and Offset fields•
are available. Values in the Width and Length fields specify the width and