10.0

Rectangles tab of ShapeMaker dialog box
In this tab, you can separately configure each corner of the box by unchecking Same for
all, or check Same for all and configure all four corners with a single set of controls.
Whichever way you do it, you can use the drop-down menu to specify a corner type
(Normal, Rounded, Beveled, Concave, Pointed, or Inset) and a diameter (for options
that involve a diameter).
Curvature: Controls how curved the corners are if you select an option that includes
curvature.
Balance: For some options, lets you control whether the corners lean toward the sides of
the box or toward the top.
Radial: For some options, lets you control whether the corners of the box are aligned with
the center of the box or not.
ShapeMaker Presets tab
The Presets tab of the ShapeMaker dialog box (Utilities > ShapeMaker) lets you store
settings that you like so that you can reuse them later.
A GUIDE TO QUARKXPRESS 10 | 375
XTENSIONS SOFTWARE