7.0

5 F
or each e-mail address to send an e-mail message to if QuarkXPress Server
stops running, click
Add to display the Add EMail Address dialog box, enter
the address in the
EMail Address field, and then click OK. You can add a
maximum of eight e-mail addresses to the list.
Add EMail Address dialog box
Click Modify to modify an existing e-mail address. Click Remove to delete an
address from the list.
6 Click the Preferences tab and configure QuarkXPress Server Monitor preferences,
as follows:
•
Query Interval: The time interval between status checks. Choose Seconds
or Minutes from the corresponding drop-down menu. The default value
is 1 minute.
The query interval depends on the average size of the rendered document. If
the average size is less than 1MB, set the query interval to 1 to 2 minutes. If it
is between 1MB and 5MB, set the query interval to 2 to 3 minutes. For docu-
ments greater than 5MB, Quark technical staff recommends a query interval
of 3 to 4 minutes.
•
Number of retries: The number of times QuarkXPress Server Monitor checks
the status of QuarkXPress Server when it receives no response from the initial
query. The default value is 10.
The optimum number of retries depends on the load on the servers.
•
Test Document: The name of a test QuarkXPress project to be used for the
determination of server status.
The test document must exist in the document pool of each of the monitored
QuarkXPress Ser
ver applications.
•
Delay on Failure: Check Use Delay in this area to make the monitor wait
before resuming the monitoring process after the detection of a ser
ver failure.
Enter the delay value in the corresponding fi
eld and choose
Minutes or Seconds
from the drop-down menu. The default delay value is 3 minutes.
CONFIGURING QUARKXPRESS SERVER MONITOR
192
|
CHAPTER 6: QUARKXPRESS SERVER MONITOR