1.1

THE AUTO PLACE DIALOG BOX
R
ather than dragging multiple copies of a mark into position, you can use the
Auto Place dialog box to place marks. Control+click/right-click a mark in the
Press Marks bar and choose Auto Place. Note that Auto Place is not available
for crop marks or trim lines.
•
Edge Offset: Enter a value in the field to specify the distance between the
trim and the nearest edge of the mark’s bounding box.
• Page Offset: Enter a value in the field to specify how far to place the marks
from the center of the page edges. A positive value moves marks clockwise;
a negative value moves marks counterclockwise from the page edges.
•
Repeat Count: If you click Distribute in the Method area, you can specify how
many copies of the mark to place. Enter a value in the field.
•
Method: Click a button to specify where the marks should be placed as
defined below.
•
Apply To: Check the boxes to indicate which sides of the pages to place
marks on.
The Auto Place dialog box.
THE AUTO PLACE DIALOG BOX
18
|
CHAPTER 2: QUARK MARKIT