User`s manual

Eagle 2000 – 2kW FM Broadcasting Amplifier
User’s manual – Page 36 of 66
10.1.c Show Timers menu
This option allows to see a page showing the number of working hours, hours with active alarms, stand by hours
.
1) In the program page (Ö 10.1), turn counterclockwise the knob scrolling down until Show timers:
2) Press the knob, the Show timers menu is shown:
• working h.: number of hours with the equipment in normal operation
• alarm h.: number of hours with the equipment showing alarms
• Stand-by h.: number of hours with the equipment in stand-by mode
3) To quit this menu and go back to the program page, press the knob (see note).
 Step 3 – If you have set some settings with the other menus of the program page, don’t forget that they aren’t still stored until
you select the option Confirm Changes and press the knob.
10.1.d Set power saver menu
This option sets a certain time in which the equipment automatically reduces its output power (e.g. during some hours in the night).
You can set both the needed power reduction as well as the low-power time in which it will be automatically set.
1) In the program page (Ö 10.1), turn counterclockwise the knob scrolling down until Set power saver:
2) Press the knob, the Set power saver menu is shown:
• For. Power %: proportional reduction of the forward power during the power saver time
• Start h.m: time in hours and minutes from which the power saver starts
• End h.m: time in hours and minutes to which the power saver ends
• Previous Menu: return to the program page
3) Move the cursor > to For. Power % (see the previous image). Press the knob to move the cursor on the right.
4) Turn the knob to set the reduction percentage and press the knob to enter the set value (see the note at the bottom).
5) To set the power saver starting time, move the cursor to the left of Start h.m:
6) Press the knob. The cursor will move on the right
of the Start h.m: