Users Manual

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device , pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
- This radio is designed for and classified as “Occupational/Controlled Use Only”, meaning it must be used only during the
course of employment by individuals aware of the hazards, and the ways to minimize such hazards;NOT intended for use in
anGeneral population/uncontrolled environment.
- DO NOT operate the radio without a proper antennaattached, as this may damage the radio and may alsocause you to
exceed RF exposure limits. Aproper antenna is the antenna supplied with this radio bythe manufacturer or an antenna
specifically authorized bythe manufacturer for use with this radio.
-DO NOT transmit for more than 50% of total radio usetime, more than 50% ofthe time can cause RF exposure
compliancerequirements to be exceeded.
- This transmitter may operate with the antenna(s) documented in this filing in Push-to-Talk and body-worn configurations. RF
exposure compliance is limited to the specific belt-clip and accessory configurations as documented in this filing and the
separation distance between user and the device or its antenna shall be at least 2.5 cm.