Getting Started Guide
73
Advanced OperationAdvanced Operation
the [MENU] key to conrm, and press the [EXIT] key to return to standby.
Repeater Tone (RPT-TONE) – Menu 46
e repeater can transmit a tone after a signal is received to acknowledge receipt of the
incoming transmission is tone can be enabled or disabled in the RPT-TONE option
(MENU 46, p.65). e repeater receipt reports the working status of the repeater to
the operator who is attempting to access it.
When the transceiver is standby, press the [MENU] + [4] + [6] keys and the screen
will display RPT-TONE. Press the [MENU] key to access the settings, and after press-
ing the [UP] / [DOWN] key to activate (ON) or deactivate (OFF) the tone, press the
[MENU] key to conrm, and press the [EXIT] key to return to standby.
Repeat Hold Timer (Programming Software Only)
e Repeating Hold Timer is used to prevent the PTT from being used to transmit
too frequently. When the PTT on the radio is released after transmitting in repeater
mode, the hold time prevents the unit from transmitting for a predermined interval
while waiting for a response. If no valid QT/DQT is detected within the hold time,