Getting Started Guide
19
Installation and SetupInstallation and Setup
Removing Front Panel from Transceiver
1. Press and hold tab on the right side of the switch-
board / front panel while sliding the front panel in
the direction of the arrow.
Front Panel to Transceiver Cable Specications
e cable connecting the front panel to the transceiver uses 8-pin RJ-45 type connec-
tors. A short cable is provided for installations where the front panel will be attached to
the transceiver. A longer extension cable is also included for use in installations where
the front panel will be mounted detached from the transceiver.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
4
3
2
5
6
7
8
1
4
3
2
5
6
7
8
Please note, a standard ethernet cable cannot be used as a re-
placement for this cable. is cable requires that pins 2 and 4 be
reversed on one of the connectors.