Getting Started Guide
Table Of Contents
- Safety Information
- Getting Started
- Operation
- Menu Functions
- [01: ABR] Backlight
- [02: SAVE] Battery Saver
- [03: TXPOW] Output Power
- [04: VOX] Voice Activated Transmit
- [05: VOX-DLY] VOX Delay
- [06: SQL] Squelch
- [07: ROGER] Roger Beep
- [08: TOT] Transmit Overtime Timer
- [09: TOA] Transmit Overtime Alarm
- [10: VOICE] Voice Guide
- [11: BEEP] Button Beeps
- [12: BCL] Busy Channel Lockout
- [13: RX-DTC] Receive CTCSS/DCS Tone
- [14: TX-DTC] Transmit CTCSS/DCS Tone
- [15: SC-REV] Scan Method
- [16: CH-NAME] Channel Name
- [17: PRI-CH] Priority Channel
- [18: PRI-SCN] Priority Scan
- [19: S-TONE] Single Tone Pulse Transmission
- [20: SC-QT] CTCSS/DCS Scan Save Options
- [21: PONMSG] Power On Message
- [22: SCN-ADD] Scan Add / Delete
- [23: SCN-GP] Scan Group
- [24: SCN-CD] CTCSS/DCS Scanning
- [25: AU-LOCK] Auto Lock
- [26: LOCK-M] Lock Mode
- [27: SECOND] Stopwatch Timer
- [28: PF1] Side Key PF1 Assignment
- [29: PF2] Side Key PF2 Assignment
- [30: RPT-RCT] Repeater Reception Confirmation
- [31: DC-VLT] Battery Voltage Display
- [32: QT-SW] Tone Scanning Compatibility Check
- [33: CH-MDF] Channel Display Mode
- [34: RESET] Factory Reset
- Troubleshooting
- Technical Information
- Optional Accessories
- Limited Warranty

7
Safety InformationSafety InformationSafety InformationSafety Information
e KG-905G is an electrical apparatus, as well as a generator of RF (Radio Frequency)
energy, and you should exercise all safety precautions as are appropriate for this type of
device.
Please read the suggestions and warnings below before using the transceiver.
⚠
Keep the transceiver and accessories out of the reach of children.
⚠
Do not disassemble the transceiver.
⚠
Only use the supplied battery pack and charger or genuine Wouxun branded
replacements purchased from an authorized dealer. Using improper batteries and
charging accessories can damage the transceiver.
⚠
e supplied antenna is tuned for the frequencies supported by this transceiver.
Using an aftermarket antenna can damage the transceiver.
⚠
Do not leave the transceiver exposed to direct sunlight or in overheated areas for an
extended period of time.
⚠
Keep the transceiver away from dusty or humid areas.










