Getting Started Guide
Table Of Contents
- Safety Information
- Getting Started
- Operation
- Menu Functions
- [01: ABR] Backlight
- [02: SAVE] Battery Saver
- [03: TXPOW] Output Power
- [04: VOX] Voice Activated Transmit
- [05: VOX-DLY] VOX Delay
- [06: SQL] Squelch
- [07: ROGER] Roger Beep
- [08: TOT] Transmit Overtime Timer
- [09: TOA] Transmit Overtime Alarm
- [10: VOICE] Voice Guide
- [11: BEEP] Button Beeps
- [12: BCL] Busy Channel Lockout
- [13: RX-DTC] Receive CTCSS/DCS Tone
- [14: TX-DTC] Transmit CTCSS/DCS Tone
- [15: SC-REV] Scan Method
- [16: CH-NAME] Channel Name
- [17: PRI-CH] Priority Channel
- [18: PRI-SCN] Priority Scan
- [19: S-TONE] Single Tone Pulse Transmission
- [20: SC-QT] CTCSS/DCS Scan Save Options
- [21: PONMSG] Power On Message
- [22: SCN-ADD] Scan Add / Delete
- [23: SCN-GP] Scan Group
- [24: SCN-CD] CTCSS/DCS Scanning
- [25: AU-LOCK] Auto Lock
- [26: LOCK-M] Lock Mode
- [27: SECOND] Stopwatch Timer
- [28: PF1] Side Key PF1 Assignment
- [29: PF2] Side Key PF2 Assignment
- [30: RPT-RCT] Repeater Reception Confirmation
- [31: DC-VLT] Battery Voltage Display
- [32: QT-SW] Tone Scanning Compatibility Check
- [33: CH-MDF] Channel Display Mode
- [34: RESET] Factory Reset
- Troubleshooting
- Technical Information
- Optional Accessories
- Limited Warranty
30
Menu Functions
[15: SC-REV] Scan Method
Function: Scan mode settings
Options: TO/CO/SE
Default: TO
TO: When a signal is detected, scanning stops. Scanning will resume if no operation
is carried out within 5 seconds. Pressing PTT will transmit on the currently
selected channel.
CO: When a signal is detected, scanning stops and resumes 5 seconds after the signal is
lost. Pressing PTT will transmit on the currently selected channel.
SE: When a signal is detected, scanning stops. Pressing PTT will transmit on the chan-
nel where the signal was detected.
[16: CH-NAME] Channel Name
Function: Allows you to edit the name for a channel. To edit a channel name, press
the [UP] and [DOWN] keys to select a character. Use the [PF2] side key
to move to the next character. e [PF1] side key will move to the previous
character. When you nish editing the name, press [MENU] to save.