Getting Started Guide
Table Of Contents
- Safety Information
- Getting Started
- Operation
- Menu Functions
- [01: ABR] Backlight
- [02: SAVE] Battery Saver
- [03: TXPOW] Output Power
- [04: VOX] Voice Activated Transmit
- [05: VOX-DLY] VOX Delay
- [06: SQL] Squelch
- [07: ROGER] Roger Beep
- [08: TOT] Transmit Overtime Timer
- [09: TOA] Transmit Overtime Alarm
- [10: VOICE] Voice Guide
- [11: BEEP] Button Beeps
- [12: BCL] Busy Channel Lockout
- [13: RX-DTC] Receive CTCSS/DCS Tone
- [14: TX-DTC] Transmit CTCSS/DCS Tone
- [15: SC-REV] Scan Method
- [16: CH-NAME] Channel Name
- [17: PRI-CH] Priority Channel
- [18: PRI-SCN] Priority Scan
- [19: S-TONE] Single Tone Pulse Transmission
- [20: SC-QT] CTCSS/DCS Scan Save Options
- [21: PONMSG] Power On Message
- [22: SCN-ADD] Scan Add / Delete
- [23: SCN-GP] Scan Group
- [24: SCN-CD] CTCSS/DCS Scanning
- [25: AU-LOCK] Auto Lock
- [26: LOCK-M] Lock Mode
- [27: SECOND] Stopwatch Timer
- [28: PF1] Side Key PF1 Assignment
- [29: PF2] Side Key PF2 Assignment
- [30: RPT-RCT] Repeater Reception Confirmation
- [31: DC-VLT] Battery Voltage Display
- [32: QT-SW] Tone Scanning Compatibility Check
- [33: CH-MDF] Channel Display Mode
- [34: RESET] Factory Reset
- Troubleshooting
- Technical Information
- Optional Accessories
- Limited Warranty
24
Menu FunctionsMenu Functions
[01: ABR] Backlight
Function: Sets the timeout of the LCD display backlight while the radio is in standby.
e timer can be set from 1-30 seconds in one second increments. It can also
be set to turn o immediately or always remain on.
Options: OFF/1-30S
Default: 10 Seconds
[02: SAVE] Battery Saver
Function: Activate the battery saver feature.
Options: ON/OFF
Default: ON
[03: TXPOW] Output Power
Function: Sets the transmit power of the radio. High power is 5 watts, Low power is
one half watt. Note, the transmit power for GMRS channels 8-14 (channel
group 2) are restricted by the FCC to .5 watts and can be used on low power
only.