User's Manual

55
How to operate
Professional FM Transceiver
56
Trouble shooting
Please check carefully if your transceiver has problems by following this chart.
If you maintain to have trouble you can reset your transceiver and very often this will eliminate your
problem.
Problem Possible Cause Possible Solution
Transceiver will not
switch on.
The receiverlight is
on and there is no
sound from the
speaker.
The powerswitch is not adjusted well.
Confirm if your CTCSS/DCS or DTMF
tone is the same as others.
Confirm if you use the right mutemode.
The batterypack is not adjust properly.
The batterypack maybe exhausted.
The batterypack is getting too old.
1.
2.
3.
Re-install the batterypack.
Charge the batterypack.
Change the batterypack.
1.
2.
3.
Turn the volumecontrol.
Reset the CTCSS/DCS.
Reset the mutemode.
1.
2.
3.
1.
2.
3.
There is no reception
Check if you have installed your antenna
right.
The signal you are receiving is very weak.
Install the supplied antenna.
Move the radio around till you
receive the desired signal or press
to reset and press again
to go to the right channel.
1.
2.
1.
2.
How to use your intelligentcharger
When the poweradapter is connected the intelligentcharger, the poweradapter should be plugged into
the matchingvoltage. The intelligentcharger will flicker once, then go into the standby mode which
means that you can charge the batterypack; When you plug in the batterypack, the intelligentcharger
will switch to red LED which means that it has being charged.
When the green light flickers, the batterypack is fully charged.
After you plug in the batterypack which the voltage is lower than 6V (it is lower than 6V if you can
not power on the transceiver), the red LED flickers which means that the batterypack is being trickle
charged by intelligentcharger and this will last about 10 minutes. When the light turns red, it will go
into the normal charge.
After you plug in the batterypack which the voltage is higher than 6V(it is higher than 6 V if you can
power on the transceiver), the red LED flickers, at this time, please confirm whether the batterypack is
plugged in right with intelligentcharger.
1.
2.
3.
4.
Press , turn on the power at the same time, the transceiver work in channel mode at this time,
press / select channel 20, the transceiver can join repeater.
3.
In frequencymode, order input + + + + + , + +
+ ; + + . Voiceprompt transmit store, press key.
0
2
0
5
4 4
2
0
4
5