User's Manual

How to operate

Setting transmit overtime prompt

When transmitter works longer than preset time, the transceiver will announce "transmit overtime" by

voice and stops transmitting. If you want to transmit again, please press PTT. (Setting overtime prompt

please see MENU 6)

Adding channelscan

Edit method: Strictly via KG-699E programming software.

Only scan according programming list which have added channel scan on programming software.

Using wireclone

Switch sourceradio on,after you have

connected the targetradio to the sourceradio

via the cloningcable,push the [MONI] key

and the sourceradio starts cloning.

Targetradio

LED is flashing red during cloning.

LED goes out in case of successful cloning.

LED glows continuous red in case of cloning

failure.

LED is flashing green during cloning.

LED will switch OFF when cloning complete.

Wireclone function

Lowvoltage batterypack voiceprompt

When the batterypack has lowvoltage, the transceiver will sound "low batterypack"voice prompt.

Professional FM Transceiver

Programming repeater function

Most repeaters use standard or different splits and/or matching CTCSS/DCS or DTMF signals.

When you need to join a repeater, you need to set different parameters on receive and transmit.

Example: The repeater transmit frequency is 450.025MHz, CTCSS value is 67Hz, the receive frequency

is 460.025MHz, CTCSS value is 254.1Hz.

When the transceiver needs to join the repeater, you need to follow the following steps:

Set receive frequency, CTCSS value and transmitting CTCSS value and store this on appointed

channel, example channel 20. The transceiver in frequencymode, setting receive frequency is

460.025MHz, receiving CTCSS value is 254.1 Hz, transmitting CTCSS vallue is 67Hz, and store to

channel 20. The operation is as follows:

In frequencymode, order input + + + + + , + +

+ , press / and select CTCSS value 254.1 + + ; + + + ,

press / and select CTCSS value 67Hz + + , + + + +

+ + voice prompt receive store, press key.

2. Setting transmitfrequency and store in appoint channel 20. The transceiver in

frequencymode, setting transmitfrequency as 450.025MHz, and store in channel 20.