User's Manual

the factory default settings (it means that the ringtone you have set and the transmitters you
have added/paired will be cleared).
INSTALLATION:
1. Plug the receiver into a mains socket and switch the socket on.
2. Place the transmitter exactly where you intend to fix and, with the doorsclosed, confirm that
the doorbell receiver still sounds when you press thetransmitter push button (If the doorbell
receiver does not sound, this maybe due to metal within the fixing surface and you may need to
repositionthe transmitter).
3. Fix the transmitter in place with (supplied) double sided adhesive tape.
ADJUSTMENTS:
1. The volume of the doorbell may be adjusted to one offive levels. Pressthe Volume button on
the receiver to increase the volume by one level,the receiver will sound to indicate the selected
level.If the maximumlevel is already set, the doorbell will switch to the minimum level, whichis
the Silent Mode.
2. The melody played by the doorbell may be set to any one of 55 differentselections. Press the
Backward or Forward button to select the nextavailable melody, the receiver will sound to
indicate the selected melody.To set the doorbell ringtone to the selected melody, please refer to
the"CHANGING THE RINGTONE' steps.
CHANGING THE BATTERY:
1. Insert the (supplied) Mini Screwdriver in the cover slot at the bottom ofthe transmitter and
twist to release the transmitter from the cover.
2. Remove the exhausted battery and dispose of properly.
3. Insert the new battery into the battery compartment. Observe correct battery polarity (+ve
and-ve), or the unit will not function and may bedamaged.
4. Refit the transmitter to the cover, with the push button at the bottom.
PROBLEMS?
If the doorbell does not sound, the following are possible causes:
1. The battery in the transmitter may be run down (the transmitter indicatorwill notflash).