User's Manual

Replace the battery.
2. The battery may be inserted the wrong way round (polarity reversed), Insert the battery
correctly, but be aware the reverse polarity may damagethe unit.
3. Ensure that the doorbell receiver is switched on at the mains.
4. Check that neither the transmitter nor the receiver are near to possiblesources of electrical
interference, such as a power adaptor, or other wireless devices.
5. The range will be reduced by obstacles such as walls, although this willhave been checked
during setup, Check that nothing, particularly ametalobject, has been placed between the
transmitter and the receiver. Youmay need to reposition the doorbell.
CAUTIONS:
1. Check that yourmains supply is correct for the doorbell receiver.
2. The receiver is for indoor use only. Do not use outside or allow to becomewet.
3.There are no user-serviceable parts. Do not attempt to repair either thetransmitter or the
receiver by yourself.
FCC Statement:
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada
licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment. The device has been evaluated to meet general RF exposure requirement.
Le matériel est conforme aux limites de dose d'exposition aux rayonnements énoncés pour fac un
autre environnement. ce dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux
rf.