User's Manual

TRANSMITTER 3: Door Sensor
THE FIRST USE GUIDE:
1.Plug the receiver into a mains socket, and switch the socket on.
2. Press the transmitter push button and confirm that the transmitter indicator flashes, the
doorbell receiver sounds "Ding-Ding" and the receiverindicator flashes. The doorbell is paired.
The default ringtone is "Ding-Dong". Users can change the ringtone easily, just refer to the
"CHANGINGTHE RINGIONE' steps.
CHANGING THE RINGTONE / PAIRING:
Step 1: Pres the (Forward) or (Backward) button on the receiver tochoose your favorite
melody.
Step 2: Press and hold down the (Volume) button on the receiver for 5seconds,until it
makes a "Ding"sound and the receiver indicatorflashes (that means the doorbell entered into the
Pairing Mode,thepairing mode will only last 8 seconds, then it will automatically exit).
Step 3: Press the button on the transmitter quickly, it will makes a "Ding-Ding"sound and the
receiver indicator flashes.
Step 4: Press the button on the transmitter again to confirm whether the current ringtone is the
one you have set, if yes, the pairing is completed.
Remark:
1.This method is also suitable for adding/pairing additional Transmitters.
2. Ifpairing door sensor, let Gap between sensor part and magnet beyond10cm (to send out the
signal) instead of Pressing the button.
CLEARING THE SETTINGS:
Press and hold down the Forward button on the receiverfor 5 seconds, until it makes a "Ding"
sound and thereceiver indicator flashes, all the settings will be cleared,the doorbell will back to