User Manual

Quanum goggle for the farsighted – 3 pages

I am farsighted – Need reading glasses – So the fresnel lenses that come with the Quanum goggles did not work

for me. Searching the web I found a combination of things that made the goggles work pretty good. Most of this

came from postings on the web.

Notes:

Quanum should have made the case 2 inches (50mm) longer since most people are needing to mount the display

outside the case.

Unlike the Fatshark goggles, I need my eyes feel slightly cross-eyed to focus on points on the screen.

Moved video display outside of case.

1) Made a balance plug Y connector so goggles and receiver could run off same battery.

2) Moved display screen to outside of case and attached ski goggles to the back.

3) Replaced fresnel lens with Harborfreight item #37708.

4) Added folding +5 diopter eyeglasses.

1) Made a balance plug Y connector so goggles and receiver could run off same battery.

 The outer red and black wire give full voltage from the 3s battery.

PAGE 1
Quanum goggle for the farsighted – 3 pages I am farsighted – Need reading glasses – So the fresnel lenses that come with the Quanum goggles did not work for me. Searching the web I found a combination of things that made the goggles work pretty good. Most of this came from postings on the web. Notes: Quanum should have made the case 2 inches (50mm) longer since most people are needing to mount the display outside the case.
PAGE 2
) Moved display screen to outside of case and added ski goggles to back..  On the left is the display hot glued to the foam frame.  On the top is the attachment for the folding +5 diopter glasses.  On the bottom you can see the cord coming out of the foam. I did this because it is less likely to have a stress break inside the display.
PAGE 3
4) Added folding +5 diopter eyeglasses.