User Manual

file:///M|/My%20Pictures/Quanum%203D/RCGroups%20Thread.txt[1/15/2016 7:20:36 PM]
RCGroups Thread: http://www.rcgroups.com/forums/showthread.php?t=2578000
I haven't flown it yet but on the bench it seems to work pretty well. Note that these are NOT the stock settings and that
I am using a RunCam HD (V1) not a mobius. The RunCam fits in the Mobius mount but DON'T use the Mobius
connector - they are wired differently!!
Both figuring out the Follow Mode and the R/C settings was a bit of a challenge. I have the Follow mode working
pretty well and setup for Follow PITCH,ROLL and Follow YAW but I may turn off the PITCH, ROLL after flight
testing
I have the R/C settings setup for Pitch and Yaw control only since I never find the need to control Roll.
I expect these settings will get tweaked after flight testing but they seem to be a good starting point.
I strongly recommend DLing the manual and reading it fully - while it's not always clear it helps a bunch. Do the
Basic and Advanced calibrations step by step as instructed in the manual and make sure the sensor (mounted in the
camera mount) stays perfectly still during each step.
Manual: http://www.basecamelectronics.com/files/v10/SimpleBGC_manual_2_4_eng.pdf
Software: http://www.basecamelectronics.com/files/SimpleBGC_GUI_2_40b8.zip
FirmWare: http://www.basecamelectronics.com/files/v10/SimpleBGC_2_40b8.enc.hex

Summary of content (5 pages)