Installation Instructions

3/8"
To Shorten the Cable of the Pendant (If in doubt, consult a qualified electrician)
Slide Pad
Spring
Adapter Holder
Adapter Cover
Set Screw
A
A
A
A
A
A
1"
1"
Adapter
Holder
Strain Relief
Strain Relief
Set Screw
1
3-b 3-c
3-a
4-a 4-b
2
Adapter Cover
Adapter Holder
Wire Nut
Adapter Cover
Adapter Holder
Cable
Cable
Slide Pad
Spring
INSTRUCTIONS
FOR ITEM: 349-6707 / 6708 / 6709 / 6710 / 6711 / 6712
UANTUS
Q
1. Remove the adapter cover from the adapter
holder by loosening the set screws (1).
Remove the slide pad and spring, and set
them aside.
2. Unscrew the wire nuts (2) and separate the
wires.
3. Adjust the length of the cable:
a.) Measure the desired length of cable
and mark "A"; Slide adapter holder down
past "A". Fold cable down and slide strain
relief downward to loosen, then remove
Strain Relief from cable (3-a).
b.) Slide cable through center smaller hole
on Strain Relief (3-b) until it is 1" above
mark "A"; Loop end of cable and slide through smaller hole on same side of
Strain Relief (3-c); Pull on both ends of cable to tighten loop, making sure that
Strain Relief is 1" above mark "A".
c.) Measure 2-3/4" from cable exiting Strain Relief (4-a), and cut off excess
cable.
d.) Measure 2" down from end of cable (4-b); cut carefully around cable and
peel off insulation to reveal 3 inner wires
CAUTION: Take care when cutting around cable - If cut too deeply, the
insulation around inner wires can be compromised.
e.) Measure 3/8" down from end of inner wires (4-b), and trim off insulation.
4. Make wire connections using wire nuts (see 2, above):
a.) Twist together the transparent with black stripe (or black) wire from the
cable and the black wire from the adapter cover.
b.) Twist together the transparent with light green stripe (or green) wire from
the cable and the green wire from the adapter cover.
c.) Twist together the transparent (or white) wire from the cable and the white
wire from the adapter cover.
Carefully put the wires back into the adapter holder.
5. Pull the cable down until the strain relief hits the bottom of the adapter holder.
Then replace the spring and slide pad (4-a), and fasten the adapter cover to
the adapter holder (4-b) with the 2 set screws.
WARNING: To avoid the risk of injury, be sure to turn off electrical
power at the fuse box while installing or servicing this fixture.
5-a 5-b
cut
trim
strip
2-3/4"
2"