Installation Instructions

ManualsBrandsQuantus ManualsIndoor LightingVictoria 1-Light Bronze Track Lighting Pendant

For Ceiling Mounting:

Bulb Type A Max.100W

(not included)

Cable

Cap Nut

Adapter

Cable

Socket Ring

Glass Shade

Glass Holder

1. Cut off the cable near the bottom of the adapter. (See Figure 1)

2. Thread the cable through the canopy and two holes of the strain

relief.

3. Measure the desired length of the cable (A) from the canopy

to the top side of the cap nut and leave an additional 9" of

cable (B) above the canopy (include the canopy). Then cut

off the unnecessary cable. (See Figure 2)

4. Adjust strain relief at 9" position from the top of the cord.

5. Mark the 3" of cord (C) from the top of the cord (B). Use

a knife to peel off the insulation of the cord (C) carefully

to expose the 3 wires on the inside. (See Figure 2)

Caution: Cutting too deep may cut off the three inside

wires and destroy the insulation surface of the three

inside wires.

6. Peel off the 3 wires from the top about 3/8" long(D) to

expose the copper for wiring.

7. Attach the mounting strap to the outlet box by using two

mounting screws.

8. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections

using the wire nuts:

a. The black wire from the fixture to the black wire from the power source.

b. The white wire from the fixture to the white wire from the power source.

c. The green grounding wire from the fixture to the green grounding wire from power source.

Carefully put wires back into the outlet box.

9. Pull the cord ( A ) down slightly until the strain relief touches the hex nut.

Note: Adjusting the strain relief of the canopy can decrease or increase the length of cord

that is exposed.

10. Attach the canopy to the mounting strap by inserting the screws, and secure it with two bolt nuts.

11. Attach the glass shade to the glass holder, then secure it with socket ring.

12. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed

wattage.

13. Turn on the power at the main fuse or circuit breaker box.

Outlet Box

Mounting Strap

Lock Nut

Mounting Screw

Screw

Wire Nut

C(3")

D(3/8")

B(9")

Figure.2

Figure.1

Strain Relief

Canopy

Bolt Nut

UANTUS