Installation and Operating Guide

10 Connecting the VLS
Connecting the Interface Cables
Note
Make sure the interface cable you are using has the appropriate connectors on each
end. If the host computer's SCSI connector is different from that on the VLS, you will
need to obtain a different cable than the one supplied with the unit. Consult your
dealer or Customer Assistance if you need help. Connect the interface cables as
shown in Figure 4 and explained in the following steps:
❐
Check that the power switches on both the VLS and the host computer are off.
❐
Attach one end of the SCSI interface cable to either connector on the rear of the
VLS. Press firmly and secure the bail locks.
VLS
Terminator
SCSI
Interface
Cable
Host Computer
Figure 4. Connecting the Interface Cables