Installation and Operating Guide

Equipment Description 21
To enable the error alarm use the
LEFT
button to select the ErrAlarm field. Use
UP
or
DOWN
to select "Y" to enable alarm or "N" to disable alarm. When
Error Alarm mode is enabled, a continuous alarm tone will sound in the event of an
error message. The alarm will sound until the condition that caused the error has been
removed or any key is pressed. To clear an error message from the display, press
ALT
and
ENTER.
If you wish to change the status of the keyboard beep, use the
RIGHT
button to
select the Kybd field. Use
UP
or
DOWN
to select "Y" to enable a beep when
you press a button or "N" to disable the beep. Press
ENTER
to make the changes
effective or press
ESC
to return to previous menu item.
Note
SCSI ID Config
Lets you select the SCSI ID for drive A, drive B and the robotics on the VLS.
Use
LEFT
or
RIGHT
to select the desired field. DA is Drive A, DB is Drive B
and AC is the robotic unit (autochanger) on the VLS. Use
UP
and
DOWN
to
scroll to the desired ID for that particular element. Press
ENTER.
Notes