Installation and Operating Guide

16 Equipment Description
Once your VLS has been connected to your host computer system and the software
has been installed, the VLS is ready for use. Just turn on the power switch, place a
magazine on the carriage and press
ALT
and then
LOAD
.
Note
If you need to change certain operating functions, you can use the front panel buttons
(as described in the next section).
Front Panel Switches and Indicators
Switches and indicators on the front of the VLS are shown in Figure 6.
Lock
Locked
LED
Power
LED
16-Character
Displa
y
Ke
y
pad
Figure 6. Front of ADIC VLS
Lock
In the locked position, you cannot access any functions of the keypad.
Display
The two-line 16-character LCD shows current drive status of the VLS,
allows access to change features or displays error messages.