User's Manual

Installation Chapter 3
STT20000N Product Manual Page 23
Figure 3-5
Mounting hole locations for drive with mounting brackets
5.49 in
(139mm)
3.12 in
(79mm)
2.08 in
(53mm)
1.81 in
(45.9mm)
3.12 in
(79,2mm)
0.197 in
(5mm)
1.7 in
(43mm)
2.36 in
(60mm)
0.62 in
(15.7mm)
0.4 in
(10.2mm)
0.51 in
(13.0mm)
0.86 in
(21.8mm)
.075 in (1.9mm)
2 PLACES
5.87 in (149.0mm)
5.76 in (146.4mm)
Cabling and connectors
The drive provides standard, single-ended SCSI transmission. ANSI SCSI
standards specify the technical requirements for correctly cabling and connecting
single-ended devices.
Either 50-pin flat cable or 25-signal twisted-pair cable with a maximum length of 6
meters (19 feet) may be used to connect the drive to its SCSI host adapter output. If
twisted-pair cabling is used, connect the twisted pairs to physically opposing
contacts on the connector. A stub length no greater than 0.1 meter should be used
off the mainline connection within any connected equipment.