User's Manual

Quantum TC2201E Installation Instructions
Document 81-81449-01 A01
July 2005
Connecting the TC2201E 9
Both Ethernet switches and hubs may allow for individual ports to be
configured for different media types. The TC2201E must be connected to the
hub or switch port with the appropriate Ethernet cabling for both the
TC2201E and the switch port to which it is connected.
To connect the TC2201E to an iSCSI network:
1 Locate the iSCSI ports on the back of the TC2201E.
Figure 8 iSCSI ports
iSCSI ports
2 With the TC2201E powered off, connect the TC2201E into the iSCSI
environment using the appropriate cabling. Be sure to insert the cable
connectors in the proper orientation.
SCSI Connection 0 The TC2201E can support Fast/Ultra160 Narrow/Wide SCSI, depending on
the specific configuration. The TC2201E is factory configured to support
LVD/Single-Ended buses. Two VHDCI 68-pin D-shell, P-type connectors are
located on the rear panel of the unit, allowing the unit to be attached at the
end of up to two SCSI buses. The TC2201E must always be installed at the end
of SCSI buses.
The TC2201E supplies termination power (TERMPWR) to each SCSI bus. An
internal self-resetting fuse in the TERMPWR will reset after a fault is cleared.