User's Manual

Quantum TC2201E Installation Instructions
Document 81-81449-01 A01
July 2005
6 Installing the TC2201E in a Rack
6 Attach the ear brackets to the TC2201E, using two of the #6-32x.312
Phillips screws on each side (as shown in
figure 3 below). Position the
front of each bracket next to the end of the TC2201E that will be facing out
of the rack (see Step 7 for more information). Tighten the screws securely.
Figure 3 Attaching the Ear
Brackets
7 If you are mounting the TC2201E in the rack with the ports facing inside
the rack (shown in Figure 2-4) or with the ports facing outside the rack
(shown in Figure 2-5), attach the front of the mounting brackets to the
rack using two of the #M6x12 Phillips screws for the front of each ear
bracket. Tighten the screws securely.
Warning: To reduce injury or equipment damage, the mounting
brackets must be level. If the brackets are not level, the
TC2201E cannot be installed correctly