User`s guide

Chapter 2 Installation Procedures
Installing the LTO Driver Software
LTO-5 Tape Drive User’s Guide 19
3 Verify that the tabletop LTO-5 Full-Height Tape Drive AC power
switch is set to the off position, and connect the AC power cord to
the power connector on the back of the drive.
4 Connect the drive AC power cord to the facility AC power
receptacle.
5 Reconnect the workstation or server system AC power cord to the
facility AC power receptacle.
After connecting the tabletop drive interface and AC power cables,
proceed to Restarting the Tabletop Full-Height Tape Drive System
in the
following subsection.
Restarting the Tabletop Full-Height Tape Drive System
After connecting the tabletop drive interface and AC power cables:
1 Set the tabletop drive AC power switch to the on position.
2 Restart the workstation or server system.
3 Verify that the tabletop LTO-5 Half-Height Tape Drive comes on and
completes the Power On Self Test (POST) functions.
As required, proceed to Installing the LTO Driver Software
.
Installing the LTO Driver Software
If you intend to use the LTO-5 Tape Drive with the Microsoft® native
backup applet on a Windows 2000, Windows Server® 2003, Windows
2008 Server®, Windows XP®, or Windows Vista operating system,
install the appropriate version of the LTO driver software available at
www.quantum.com
.
Note: The LTO driver software is not necessary with commercial
backup application software.