User`s guide

Chapter 2 Installation Procedures
Installing the Internal LTO-5 Tape Drive
10 LTO-5 Tape Drive User’s Guide
4 Position the drive in the bay and align either the upper or lower
mounting holes—whichever is appropriate—with the holes in the
chassis (see figure 4
).
5 Secure the drive using two Phillips screws labeled General
Mounting Screws on each side of the tape drive. If you cannot
tighten the Phillips screws, use the washers provided with the
General Mounting Screws.
Caution: Using screws other than the Phillips screws labeled as
General Mounting Screws can damage the tape drive.
Do not use screws other than the General Mounting
Screws to secure the internal LTO-5 Half-Height Tape Drive.
After mounting the internal LTO-5 Half-Height Tape Drive, proceed to
Connecting the Internal Half-Height Drive Interfaces
in the following
subsection.
Figure 4 Internal Tape Drive
Mounting Hole Locations
Lower mounting holes
Upper mounting holes
Washer