User's Manual

Chapter 3 Using Your Tape Drive
Updating the Firmware
SDLT 600A Product Manual 39
Rebooting the Tape Drive 3 A system reset is available through a reboot command on the SDLT 600A
main page.
To reboot:
1 Click
Reboot on the left side of the page.
Figure 30 Reboot in Progress
This will launch a configuration confirmation window.
Figure 31 Save Changes Window
2 Click OK.
A restart confirmation window displays.
Note: Always remove the tape before turning off the SDLT 600A.
A tape cartridge can be unloaded during an active FTP session
only by using the built-in FTP client. Right-click within the
right pane of the FTP client window to display the
Contextual
menu, then click
Eject tape.