User's Manual

Chapter 2 Installing Your Tape Drive
Installing the Tape Drive
SDLT 600A Product Manual 10
4 Connect one end of an Ethernet cable to the network port located on
the rear of the tape drive and connect the other end to a network
switch or router (see Connecting the SDLT
600A to the Network
Port).
5 Power on the tape drive using the switch on the front panel of the
rackmount unit (see figure 4
).
Figure 4 Power on the
Rackmount Tape Drive
Connect the Power to the
Tabletop Tape Drive
2
The tabletop tape drive power supply has an auto-sensing feature; it
requires no adjustment or switch setting changes for different AC
sources.
1 Attach the power cable to the tape drive.
2 Connect one end of the AC cord into the power connector on the rear
of the tape drive; connect the other end of the cord to the AC outlet.
Note: The GigE network port is backward compatible with
100BaseT and 10BaseT networks. To get the full
performance of the SDLT 600A, it is advisable to use a
GigE network.
Power button