User's Manual

Chapter 2 Installation and Configuration
Setting the Change Mode
48 SuperLoader User’s Guide
To Start Sequential Mode Operation: 2
1 On the main menu, scroll to
Commands, then press Enter.
Figure 41 Main Menu
(LCD)
2 On the Commands menu, scroll to Sequential Ops, then press Enter.
3 On the Sequential Ops submenu, scroll to
Start, then press Enter.
Moving first tape to drive appears on the LCD.
To Stop Sequential Mode Operation: 2
1 On the main menu, scroll to
Commands, then press Enter.
Figure 42 Main Menu
(LCD)
2 On the Commands menu, scroll to Sequential Ops, then press Enter.
3 On the Sequential Ops submenu, scroll to
Stop, then press Enter.
Ejecting tape from drive appears on the LCD.
Status
Commands
Configuration
Diagnostics

Status
Commands
Configuration
Diagnostics
